-
Filter by Topic
Release
Popular Topics
- List all discussions
LinkedIn
Facebook
Twitter
Delicious
Digg
Stumbleupon
More services...How to set the time step dt to a specific value when calculating for transient problem
|
Thread index | Previous thread | Next thread | Start a new discussion |
RSS feed |
Turn on email notifications |
2 Replies
Last post: November 6, 2012 2:45am UTC
November 3, 2012 8:05am UTC
How to set the time step dt to a specific value when calculating for transient problem
Hello everybody,
I am now simulating a transient problem using Electric current mode but I do not know how to set up the time step dt to a specific value. Anybody have experiences about this, please help me.
Thank you very much.
Nam
Reply | Reply with Quote | Send private message | Report Abuse
November 3, 2012 12:23pm UTC in response to Nhat Nam Nguyen
Re: How to set the time step dt to a specific value when calculating for transient problem
Hi
you define the time stepping in the time dependent solver node, COMSOl will choose it's own stepping and save the results at your difined time steps, by default, you can chenge these settings down in the solver sub-nodes
--
Good luck
Ivar
Reply | Reply with Quote | Send private message | Report Abuse
November 6, 2012 2:45am UTC in response to Ivar Kjelberg
Re: How to set the time step dt to a specific value when calculating for transient problem
Dear Mr. Ivar,
Thank you very much for your response.
Best Regards,
Nam
Reply | Reply with Quote | Send private message | Report Abuse
Rules and guidelines
