Community > Discussion Forum > study

Discussion Forum

study

Topics: Solving

Thread index  |  Previous thread  |  Next thread  |  Start a new discussion

RSS FeedRSS feed   |   Email notificationsTurn on email notifications   |   1 Reply   Last post: December 5, 2012 7:28pm UTC
Eba Flora

Eba Flora

December 5, 2012 5:25pm UTC

study

Sir,
In frequency domain study, in stationary solver there are options like automatic, linear, linearized and non'linear which is to be shown. Is there any need to change the relative tolerance value

Reply  |  Reply with Quote  |  Send private message  |  Report Abuse

Ivar Kjelberg

Ivar Kjelberg

December 5, 2012 7:28pm UTC in response to Eba Flora

Re: study

Hi

I use 80-90% ofthe time the defaut settings, even I would say I start always with the default settings, it's only when the solver does not converge, and I'm convinced that nothing else than the solver tweaking is in cause, then I take a closer look to those settings

But that is my way, others that have their own ideas on which solver might be more rapid tendto tweak quicker, it's all wery model dependent

--
Good luck
Ivar

Reply  |  Reply with Quote  |  Send private message  |  Report Abuse


Rules and guidelines