Community > Discussion Forum > Adding physical parameters

Discussion Forum

Adding physical parameters

Topics: 4.2

Thread index  |  Previous thread  |  Next thread  |  Start a new discussion

RSS FeedRSS feed   |   Email notificationsTurn on email notifications   |   1 Reply   Last post: January 3, 2013 2:09pm UTC
Michel Roy

Michel Roy

December 30, 2012 4:18pm UTC

Adding physical parameters

Hi
I have question,please help me
I want to add some physical parameters to my waveguides,how can i do this?
both of them is:
parameter: signal absorption cross section at 1527nm (σ12) value:4.8*10e-21 Cm2
parameter: overlap factor (Γp,s) value:0.85

thanks

Reply  |  Reply with Quote  |  Send private message  |  Report Abuse

Ivar Kjelberg

Ivar Kjelberg

January 3, 2013 2:09pm UTC in response to Michel Roy

Re: Adding physical parameters

Hi

you must ask yourself where these parameters enter the PDE governing your physics, and enter them accordingly, I'm not so familiar with those variables, so probably you need to transform them somewhat to enter a loss factor or other phase terms

--
Good luck
Ivar

Reply  |  Reply with Quote  |  Send private message  |  Report Abuse


Rules and guidelines