-
Filter by Topic
Release
Popular Topics
- List all discussions
LinkedIn
Facebook
Twitter
Delicious
Digg
Stumbleupon
More services...High current output
|
Thread index | Previous thread | Next thread | Start a new discussion |
RSS feed |
Turn on email notifications |
3 Replies
Last post: January 18, 2013 1:22pm UTC
January 18, 2013 8:12am UTC
High current output
Hi everyone,
I am simulating a heat treatment with the induction heating module and I'm facing a problem concerning the single turn coil.
More specific I import as a coil excitation the a power of 640kW and I get a voltage of 120V and 10700A.
The voltage is fine, but the current is the double of what I expected. Any ideas of how can I fix this or check what's wrong?
Thank you!
Rosa
Reply | Reply with Quote | Send private message | Report Abuse
January 18, 2013 8:23am UTC in response to Rosa Papadopoulou
Re: High current output
Hi
could it be an issue with a mix of Amplitudes and RMS values ?
--
Good luck
Ivar
Reply | Reply with Quote | Send private message | Report Abuse
January 18, 2013 12:18pm UTC in response to Ivar Kjelberg
Re: High current output
I haven't specified any value as a rms so there is no mix. Right?
Reply | Reply with Quote | Send private message | Report Abuse
January 18, 2013 1:22pm UTC in response to Rosa Papadopoulou
Re: High current output
Hi
not necessarily, normally we specify amplitudes, but depending on the physics (and the version) at some stage COMSOL proposed back RMS values for frequency sweep analysis, need to look up the appropriate doc (corresponding to your current version, or dig into the COMSOL equations (preferences view equations on)
--
Good luck
Ivar
Reply | Reply with Quote | Send private message | Report Abuse
Rules and guidelines
