Properties of model

Thread index  |  Previous thread  |  Next thread  |  Start a new discussion

RSS FeedRSS feed   |   Email notificationsTurn on email notifications   |   3 Replies   Last post: February 26, 2013 1:43pm UTC
Zdeno Zitny

Zdeno Zitny

February 24, 2013 12:53pm UTC

Properties of model

Hey.

How can I check the properties of the model object?
For example, the current in the coil, or the radius of the circle, the properties of the materials.

Thank you.

Reply  |  Reply with Quote  |  Send private message  |  Report Abuse

Ivar Kjelberg

Ivar Kjelberg

February 25, 2013 7:08pm UTC in response to Zdeno Zitny

Re: Properties of model

Hi

you can only post-process after having solved, or loaded the initial conditions, then you can use the Derived values node to integrate and interprete results around your domains or boundaries

--
Good luck
Ivar

Reply  |  Reply with Quote  |  Send private message  |  Report Abuse

Zdeno Zitny

Zdeno Zitny

February 26, 2013 12:08pm UTC in response to Ivar Kjelberg

Re: Properties of model

Thank you for your reply.

But I had in mind early formula
geom1.feature.create c1 = ('c1', 'Circle');
You can find out where the property value before calculating.

Thank you.

Reply  |  Reply with Quote  |  Send private message  |  Report Abuse

Ivar Kjelberg

Ivar Kjelberg

February 26, 2013 1:43pm UTC in response to Zdeno Zitny

Re: Properties of model

Hi

you can do measurements in the graphics view see the ruler icon, but any "calculation" is performed on the discretized geometry, hence you need a mesh and at least loading in the initial conditions into the Data sets

--
Good luck
Ivar

Reply  |  Reply with Quote  |  Send private message  |  Report Abuse


Rules and guidelines