Message:

Topics: RF Module, 4.3a

Thread index  |  Previous thread  |  Next thread  |  Start a new discussion

RSS FeedRSS feed   |   Email notificationsTurn on email notifications   |   2 Replies   Last post: May 30, 2013 1:02am UTC
Constantinos Tsangarides

Constantinos Tsangarides

April 4, 2013 8:14pm UTC

Message:

What does this message mean:

Parametric solver does not support geometry and mesh dependent parameters?

It solved me things but not sure if it is correct.

Reply  |  Reply with Quote  |  Send private message  |  Report Abuse

Ivar Kjelberg

Ivar Kjelberg

April 4, 2013 8:59pm UTC in response to Constantinos Tsangarides

Re: Message:

Hi
In which context did you get that error, if you have selected a Solver Continuation parametrical sweep then it is because that is NOT looping over the geoemtry and the mesh.

To perform a parametric sweep to change the geoemtry and to remesh you need to add a separate "parametric Sweep" node before your solver node

--
Good luck
Ivar

Reply  |  Reply with Quote  |  Send private message  |  Report Abuse

Pu

Pu

May 30, 2013 1:02am UTC in response to Ivar Kjelberg

Re: Message:

Hi, Ivar!

I also have this problem now. How could I do what you said? Is it described in documentation?

Thanks!
--
Pu, ZHANG ??
Departamento de Física Teórica de la Materia Condensada,
Universidad Autónoma de Madrid,
Madrid, Spain.

Reply  |  Reply with Quote  |  Send private message  |  Report Abuse


Rules and guidelines