Using the assembly form

Thread index  |  Previous thread  |  Next thread  |  Start a new discussion

RSS FeedRSS feed   |   Email notificationsTurn on email notifications   |   0 Replies   Last post: May 6, 2013 1:28pm UTC
Javier Martin

Javier Martin

May 6, 2013 1:28pm UTC

Using the assembly form

Hello,


I am trying to simulate with "piezolectric devices". Specifically, I would like to exert stress on a thin film in contact with a piezoelectric 3D block. The geometry is quite simple but in order to mesh the thin film using "swept" I have to use "assembly" finish form (if I am right).

The problem is that during the simulation, it seems that both 3D piezoelectric block and thin film does not interact in any way (i.e. stress is not exerted).

I have played with "contact pairs" and "indetity pairs" with no success ! I am getting desesperate.

Any suggestion ?


Thanks !

Javier.

Reply  |  Reply with Quote  |  Send private message  |  Report Abuse


Rules and guidelines