FAN inside a geometry

Topics: 4.3, CFD, Fluid Flow

Thread index  |  Previous thread  |  Next thread  |  Start a new discussion

RSS FeedRSS feed   |   Email notificationsTurn on email notifications   |   2 Replies   Last post: October 30, 2013 4:47pm UTC
Matthias Flatscher

Matthias Flatscher

October 28, 2013 4:29pm UTC

FAN inside a geometry

Hi,

I have found the following discussion [1] but it is already two years old. I'm trying to add a fan inside my 2D - geometry. A housing surrounded by air and I want to get this air inside my housing. Is there a possibility to do that???

I tried it like it is discussed in [1] but I wasn't able to implement the fan, I'm using Conjugate Heat Transfere.

[1] www.comsol.com/community/forums/general/thread/16970

BR

Reply  |  Reply with Quote  |  Send private message  |  Report Abuse

Matthias Flatscher

Matthias Flatscher

October 29, 2013 4:38pm UTC in response to Matthias Flatscher

Re: FAN inside a geometry

I'm trying to add a fan since two days and I just can't fix it.

Is there any possebility to add an internal flow for a turbulent model???

Reply  |  Reply with Quote  |  Send private message  |  Report Abuse

Matthias Flatscher

Matthias Flatscher

October 30, 2013 4:47pm UTC in response to Matthias Flatscher

Re: FAN inside a geometry (turbulent)

Hi,

I atteched my model, maybe someone has a clue how to get the fluid from "outside" into my housing.

BR

Reply  |  Reply with Quote  |  Send private message  |  Report Abuse


Rules and guidelines