Community > Discussion Forum > Modelling a mixture in a centrifuge

Discussion Forum

Modelling a mixture in a centrifuge

Topics: no topics

Thread index  |  Previous thread  |  Next thread  |  Start a new discussion

RSS FeedRSS feed   |   Email notificationsTurn on email notifications   |   0 Replies   Last post: July 30, 2010 7:26pm UTC
Shahriar Khushrushahi

Shahriar Khushrushahi

July 30, 2010 7:26pm UTC

Modelling a mixture in a centrifuge

Hi

Im trying to model the separation of a mixture in a centrifuge. I am setting up the problem as a 2D axisymmetric problem using the Mixture Model application mode.

I want to be able to set a phi directed velocity but I dont know how to do this. The Swirl module allows for setting the phi directed velocity but assumes a single phase fluid.

I cannot set the phi directed velocity in any of the boundary conditions using the mixture model application mode.

Any suggestions will be greatly appreciated
Shahriar

Reply  |  Reply with Quote  |  Send private message  |  Report Abuse


Rules and guidelines