Simulation Methods and Teaching
|
A Simplified Numerical Model for Simulating Sliding Door and Surgical Staff Movement in an Operating Theater
C. Balocco1 1Dipartimento di Energetica, Università di Firenze, Firenze, Italy |
|
Ammonia Removal From Water by a Liquid-Liquid Membrane Contactor Under a Closed Loop Regime
E. Licon1 S. Casas1 A. Alcaraz1 J.L. Cortina1 C. Valderrama1 1Universitat Politécnica de Catalunya, Barcelona, Spain |
|
Battery Pack Temperature Distribution Simulation with COMSOL and MATLAB®
M. Masomtob1 C. Schaeper1 W. Zhou1 D. Uwe Sauer1 1Electrochemical Energy Conversion and Storage Systems Group, Institute for Power Electronics and Electrical Drives (ISEA), RWTH Aachen University, Aachen, Germany |
|
Bone Remodeling Following Total Hip Replacement: Short Stem Versus Long Stem Implants
M.S. Yeoman1 A. Cizinauskas1 C. Lowry2 G. Vincent3 S. Collins3 D. Simpson3 1Continuum Blue, Tredomen, Ystrad Mynach, United Kingdom 2Corin Group, Cirencester, United Kingdom 3Imoprhics, Manchester, United Kingdom |
|
Building Energy Simulation Using the Finite Element Method
J. van Schijndel1 1Eindhoven University of Technology, Eindhoven, The Netherlands |
|
COMSOL as an Aid in the Teaching (Learning) of Heat Transfer
R. López1 J. Morales*1 M. Vaca1 A. Lizardi1 H. Terres1 G. Bautista1 A. Lara1 1Universidad Autonoma Metropolitana, Tlalpan, Distrito Federal, Mexico |
|
Design of MEMS based Polymer Microphone for Hearing Aid Application
V. S. Nagaraja1 Ramanuja H. S.1 Deepak K1 S. L. Pinjare1 1Electronics and Communication Engineering, Nitte Meenakshi Institute of Technology, Bangalore, Karnataka, India |
|
Determination and Verification of the Forchheimer Coefficients for Ceramic Foam Filters using COMSOL CFD Modeling
M.W. Kennedy1 K. Zhang1 J.A. Bakken1 R.E. Aune1 1Norwegian University of Science and Technology, Trondheim, Norway |
|
Development of the Service Frame for SBS Tracker GEM and TENDIGEM Development
F. Noto1 E. Cisbani2 F. Librizzi1 F. Mammoliti3 C.M. Sutera1 1Istituto Nazionale Fisica Nucleare - Sezione di Catania, Catania, Italy; Dipartimento di Fisica ed Astronomia, Università di Catania, Catania, Italy 2Istituto Nazionale Fisica Nucleare - Sezione di Roma, Roma, Italy; Istituto Superiore di Sanità, Roma, Italy 3Istituto Nazionale Fisica Nucleare - Sezione di Catania, Catania, Italy; Dipartimento di Fisica ed Astronomia, Università di Catania, Catania, Italy |
|
Early Stage Melt Ejection in Laser Percussion Drilling
T. Eppes1 1University of Hartford, Hartford, CT, USA |
|
Electrochemical Impedance Spectroscopy of a LiFePO4/Li Half-Cell
M. Cugnet1 I. Baghdadi1 M. Perrin1 1INES - CEA, Grenoble, France |
|
Finite Element Convergence and Speed-Up Studies Using COMSOL Multiphysics and LiveLink™ for MATLAB® with Large Assembly Models
H. Pourzand1 A.H. Aziz1 A. Singh1 1Pennsylvania State University, State College, PA, USA |
|
Fretting Wear and Fatigue Analysis of a Modular Implant for Total Hip Replacement
M.S. Yeoman1 A. Cizinauskas1 D. Rangaswamy1 1Continuum Blue, Tredomen, Ystrad Mynach, United Kingdom |
|
Geometric Modeling and Numerical Simulation of Airfoil Shapes Using Integrated MATLAB® and COMSOL Multiphysics
A. Safari1 H. Lemu G.1 H. Severson1 1University of Stavanger, Stavanger, Norway |
|
Heat, Air, and Moisture (HAM) Modeling of Historic Windows
H.L. Schellen1 1Eindhoven University Of Technology, Eindhoven, The Netherlands |
|
Highly Concentrated Solar Radiation Measurement by Means of an Inverse Method
L. Mongibello1 N. Bianco2 R. Fucci1 F. Moscariello2 1ENEA - Italian National Agency for New Technologies, Energy and Sustainable Economic Development, Portici, Italy 2DETEC - Università degli Studi di Napoli Federico II, Napoli, Italy |
|
Investigation of the Effect of Spinal Defects on Spondylolysis and Stress Fracture of Vertebral Bodies
M.S. Yeoman1 C. Quah2 A. Cizinauskas1 K. Cooper1 D. McNally5 B. Boszczyk2 1Continuum Blue, Tredomen, Ystrad Mynach, United Kingdom 2The Centre for Spinal Studies and Surgery, Queen’s Medical Centre, Nottingham, United Kingdom 5Bioengineering Research Group, Faculty of Engineering, The University of Nottingham, Nottingham, United Kingdom |
|
Irrotational Motion of an Incompressible Fluid Past a Wing Section in an Unbounded Region
J. Russell1 1Florida Institute of Technology, Melbourne, FL, USA |
|
Load Cell Design Using COMSOL Multiphysics
A. Marchidan1 T. Sullivan1 J. Palladino1 1Trinity College, Hartford, CT, USA |
|
Modeling of Active Infrared Thermography for Defect Detection in Concrete Structures
S. Carcangiu1 B. Cannas1 G. Concu2 N. Trulli3 1Department of Electric and Electronic Engineering, University of Cagliari, Cagliari, Italy 2Department of Civil Engineering, Environmental and Architecture, University of Cagliari, Cagliari, Italy 3Department of Architecture and Planning, University of Sassari, Alghero, Italy |
|
Modeling of Chloride Transport in Cracked Concrete: a 3-D Image–Based Microstructure Simulation
Y. Lu1 E. Garboczi1 D. Bentz1 1National Institute of Standards and Technology, Gaithersburg, MD, USA |
|
Modelling of Pressure Profiles in a High Pressure Chamber using COMSOL Multiphysics
P. S. Rao1 C. K. Chandra1 1Agricultural and Food Engineering Department, Indian Institute of Technology Kharagpur, West Bengal, India |
|
Multiphysics Modeling of Warm-Air Drying of Potatoes Slices
S. Sandoval Torres1 A. de Lourdes Allier González1 L.L. Méndez Lagunas1 1Instituto Politécnico Nacional, CIIDIR, Oaxaca, Mexico |
|
Multiphysics Software Applications in Reverse Engineering
W. Wang1 K. Genc2 1University of Massachusetts, Lowell, MA, USA 2Simpleware, Exeter, United Kingdom |
|
Nondestructive Testing of Composites Using Model Based Design
E. Nesvijski1 1ACOUSTICS@MBD CONSULTANTS, LLC, Westborough, MA, USA |
|
Nonstandard High Voltage Electric Insulation Models
T. Christen1 1ABB, Corporate Research, Zürich, Switzerland |
|
Numerical Simulation of Warm-Air Drying of Mexican Softwood (Pinus Pseudostrobus)
S. Sandoval Torres1 E. Hernández-Bautista1 J. Rodríguez-Ramírez1 A. Carrillo Parra2 1Instituto Politécnico Nacional, CIIDIR, Oaxaca, Mexico 2Facultad de Ciencias Forestales, Universidad Autónoma de Nuevo León, Linares, N.L. México |
|
Numerically Generated g-functions for Ground Coupled Heat Pump Applications
J. Acuna1 M. Fossa2 P. Monzó1 1KTH Energy Technology, Stockholm, Sweden 2Dime, University of Genova, Genova, Italy |
|
Optimization of Thermal Properties Identification of Complex Thin Films Using MATLAB® and COMSOL Multiphysics
N. Semmar1 B. Wane1 1GREMI, UMR7344, CNRS-University of Orleans, Orléans Cedex 2, France |
|
Photon Migration Through Multiple Layers of Biological Tissue
M.S. Yeoman1 E. Sultan2 1Continuum Blue, Tredomen, Ystrad Mynach, United Kingdom 2College of Technological Studies, PAAET, Adailiyah, Kuwait |
|
Simplified Numerical Model of an Axial Impeller
A.-M. Georgescu1 S.-C. Georgescu2 1Hydraulics and Environmental Protection Department, Technical University of Civil Engineering, Bucharest, Romania 2Hydraulics Department, University “Politehnica”, Bucharest, Romania |
|
Simulation of Pumping Induced Groundwater Flow in Unconfined Aquifer Using Arbitrary Lagrangian-Eulerian Method
Y. Jin1 E. Holzbecher1 S. Ebneth2 1Department of Applied Geology, Georg-August-University, Göttingen, Germany 2Hoelscher Dewatering, Haren, Germany |
|
Simulation Organogenesis in COMSOL: Deforming and Interacting Domains
D. Iber1 D. Menshykau1 1D-BSSE, ETH Zurich, Basel, Switzerland |
|
Solving a Two-Scale Model for Vacuum Drying by Using COMSOL Multiphysics
S. Sandoval Torres1 1Instituto Politécnico Nacional, CIIDIR, Oaxaca, Mexico |
|
Stress and Fatigue Analysis of Subsea Umbilical and Cable Systems
M.S. Yeoman1 V. Sivasailam1 T. Poole3 S. Ingham3 1Continuum Blue, Tredomen, Ystrad Mynach, United Kingdom 3JDR Cable Systems, Littleport, Cambridgeshire, United Kingdom |
|
The Refinement of the Contact Compression Ring Chamfer for Race Engine Conditions
M. Dickinson1 N. Renevier2 W. Ahmed3 1Racing to Research team, School of Computing, Engineering and Physical Sciences, University of Central Lancashire, Preston, United Kingdom 2The Jost Institute, School of Computing, Engineering and Physical Sciences, University of Central Lancashire, Preston, United Kingdom 3Institute of Nanotechnology and Bioengineering, School of Computing, Engineering and Physical Sciences, University of Central Lancashire, Preston, United Kingdom |
|
Thermo-Acoustic Analysis of an Advanced Lean Injection System in a Tubular Combustor Configuration
A. Giusti1 A. Andreini1 B. Facchini1 F. Turrini2 Ignazio Vitale2 1Department of Energy Engineering, University of Florence, Florence, Italy 2Avio, Turin, Italy |
|
Using COMSOL for Optimal Design of Engineering Barriers of Nuclear Waste Repositories
L.M. de Vries1 A. Nardi1 A.E. Idiart1 P. Trinchero1 J. Molinero1 F. Vahlund2 H. von Schenck2 1Amphos 21, Barcelona, Spain 2Swedish Nuclear Fuel and Waste Management, Stockholm, Sweden |
|
Utilization of COMSOL Multiphysics' JAVA API for the Implementation of a Micromagnetic Modeling and Simulation Package with a Customized User Interface
L. Teich1 A. Hütten2 C. Schröder1 1Department of Engineering Sciences and Mathematics, Computational Materials Science & Engineering (CMSE), University of Applied Sciences Bielefeld, Bielefeld, Germany 2Department of Physics, Thin Films and Nanostructures, Bielefeld University, Bielefeld, Germany |
|
Web Based Laboratories for Teaching Electromagnetics for TEMPUS eLab Project
Y. El-Qattan 1 H. Ghali1 1Electrical Engineering Department, The British University in Egypt (BUE), El Sherouk City, Egypt |
Share it on Social Media:
