Design Optimization of an Electronic Component with an Evolutionary Algorithm Using a MATLAB-COMSOL Based Model
E. Pelster, and D. Wenger
Wenger Engineering GmbH
Electric construction components exposed to alternating high voltage have to withstand a significant amount of thermal loads and, resulting from the changes in Temperature , structural stresses. In order to achieve minimization of these loads, optimizing the geometry can be a helpful tool in the design process. In this study COMSOL is used to predict thermal and mechanical loads on a high ...
Y. Jin, E. Holzbecher, and P. Oberdorfer
A novel method for groundwater lowering, which can be applied at construction sites, for aquifer remediation measures or in open mining, is proposed. In contrast to conventional techniques, dewatering is achieved without water conveyance. In this paper the physical concept of the new technology, referred as single borehole pump & inject, is modeled using COMSOL Multiphysics. Two and three ...
F. Maier, K. Hebig, Y. Jin, and E. Holzbecher
Georg-August Universität Göttingen, Göttingen, Germany
Technical University Berlin, Berlin, Germany
The authors present a closer look on the Single-Well Injection-Withdrawal Experiment (SWIW) or Push-Pull Experiments and its ability to determine the groundwater velocity, as one of the major parameters concerning reservoir management and underground reservoir characterization. The flow field is modeled using analytic and numerical solutions. Different modes like Darcy-law, solute-transport and ...
H. T. D. Grigg, and B. J. Gallacher
Newcastle upon Tyne
Tyne and Wear, UK
This paper presents ongoing research aimed at development of a MEMS magnetometer capable of nanoTesla sensitivity. Such a device would pave the way for inertial-grade MEMS IMUs. A resonant sensor is proposed, based on a Xylophone Bar sense element, and is analysed both directly and via COMSOL. Mode shapes and frequencies are found as functions of geometric parameters, and the results used ...
J. Förster, and H. Vogt
Institute of Electronic Components and Circuits
A one-dimensional model of Excimer Laser-Annealing of amorphous silicon layers which are irradiated with a KrF excimer laser is described. For realisation, the application mode heat transfer in solids is used. The model predicts a melt threshold for the energy density of the laser of 88.5 mJ/cm^2. It also predicts a linear increase of the melt duration with a slope of approximately 625 ...
G. C. Bandlamudi[1,2], C. Siegel, C. Heßke, and A. Heinzel[1,2]
ZBT Duisburg, Duisburg, Germany
University of Duisburg-Essen, Duisburg, Germany
High temperature polymer electrolyte membrane fuel cells (HT PEMFCs) are very promising technologies when used in combined cooling and heating power (CCHP) systems. They are operated at 160°C, offering the possibility of high tolerance to fuel impurities and a possibility to use the heat generated for cooling and heating purposes, leading to higher total system efficiency. Employing a ...