The powerpoint slides contain step-by-step instructions on how to install and run COMSOL on a cluster. Models for cluster testing are available in the Model Library: COMSOL Multiphysics->Tutorial models>micromixer_batch and...
This tutorial illustrates how to use the Single-Turn Coil Domain and Multi-Turn Coil Domain features for modeling 3D coils. Both DC and AC coil modeling strategies are discussed. A series of simple illustrative tutorials are used to show...
This presentation provides an overview of LiveLink™ for MATLAB®. LiveLink™ for MATLAB® allows you to integrate COMSOL Multiphysics with MATLAB to extend your modeling with scripting and to build your own applications that...
This tutorial shows how to model transient heat conduction in a glass slab heated by a laser beam. The tutorial emphasizes on the use of functions to model the laser power as a body heat source. Several key design variables have been...
A silicon wafer is heated up by a laser that moves radially in and out over time. In addition, the wafer itself is rotated on its stage. The incident heat flux from the laser is modeled as a spatially distributed heat source on the...
This is a general introduction to the AC/DC Module. Statics and Low-Frequency applications are exemplified as well as common multiphysics simulations: Joule heating and induction heating
The tonpilz (sound mushroom) piezo transducer is a transducer for relatively low frequency, high power sound emission. The transducer consists of piezoceramic rings stacked between massive ends and pre-stressed by a central bolt. The...
This is an overview presentation on the elastic waves and piezoelectric modeling features of COMSOL Multiphysics. The focus here is on piezo-features and especially COMSOL's strength in that you are allowed to mix dielectric, elastic,...
The following model examines unsteady, incompressible flow past a long cylinder placed in a channel at right angle to the oncoming fluid. The cylinder is offset somewhat from the center of the flow to make the steady-state symmetrical...
The development of mixers does often not only have to account for effectiveness, but also other factors must be involved, such as cost and complexity for manufacturing. The three models study a laminar static micro mixer with two parallel...
