assign pressure to line geometry in 3D

Thread index  |  Previous thread  |  Next thread  |  Start a new discussion

RSS FeedRSS feed   |   Email notificationsTurn on email notifications   |   0 Replies   Last post: January 11, 2017 10:14am UTC
Hwajung Yoo

Hwajung Yoo

January 11, 2017 10:14am UTC

assign pressure to line geometry in 3D

Hello,

I have a question about assigning pressure to a line in 3D geometry.

I want to assign pressure of 0 in a line as a well in porous 3D media in Darcy's law module.
I tried with pointwise constraint, and wrote '0-P' in constraint expression.
The study is computed without any errors, but the pressure seems to be not assigned according to the result.
I wondered if there was any way for this!

thank you!


Hwajung

Reply  |  Reply with Quote  |  Send private message  |  Report Abuse


Rules and guidelines