Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Apply voltage to a 2D network in a 3D model

Posted Apr 26, 2016, 5:45 a.m. EDT Modeling Tools & Definitions, Parameters, Variables, & Functions Version 5.2 0 Replies

Shujun Xian
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello,

I would like to know is it possible to apply voltage to a 2D network in a 3D model? The 2D network is supposed to be conductive, with a 3D insultaive substrate.

I tried to do it but fail. In the 2D network, except the two electrodes that I apply a electrical potential condition or ground condition, all other entities are treated as electric insulation by default. Therefore, it's impossible for current to through the network.

Do anyone know how to solve this problem? I have the mph file attached. Thank you for the help in advance.

Regards,
Shujun
0 Replies Last Post Apr 26, 2016, 5:45 a.m. EDT
COMSOL Moderator

Hello Shujun Xian

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content