Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How to make animation in control

Please login with a confirmed email address before reporting spam

I want to simulate the wave propagating in plate, but the animation show the stress deformation is out of the border of material, as i show in attachment.
what's the reason?


2 Replies Last Post Sep 29, 2016, 3:33 p.m. EDT
Dave Greve Certified Consultant

Please login with a confirmed email address before reporting spam

Posted: 7 years ago Sep 29, 2016, 12:18 p.m. EDT
Your question is not very clear (and your image does not include the legend so that I can see what you are plotting).

You are apparently plotting the deformation. You can turn off the deformation plot (and just use color to show deformation or stress). Alternatively you can adjust the scale factor used for the deformation plot.

DW Greve
Your question is not very clear (and your image does not include the legend so that I can see what you are plotting). You are apparently plotting the deformation. You can turn off the deformation plot (and just use color to show deformation or stress). Alternatively you can adjust the scale factor used for the deformation plot. DW Greve

Please login with a confirmed email address before reporting spam

Posted: 7 years ago Sep 29, 2016, 3:33 p.m. EDT
Thank you, I get the ponit, I will be down,
Thank you, I get the ponit, I will be down,

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.