Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

how to access pressure value at boundary of membrane ?:PEM fuel cell modelling

Posted Jan 12, 2017, 1:04 a.m. EST Fluid & Heat, Computational Fluid Dynamics (CFD), Battery Design, Chemical Reaction Engineering Version 5.2 0 Replies

Akanksha Nawale
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I am modelling a low temperature PEM fuel cell model using the application library of HT-PEM fuel cell. I need to model electro-osmotic flow in the membrane. For this I need pressure value at the boundary of membrane as shown in the figure marked in blue and red.
The initial conditions of pressure are given at inlet and outlet of gas channels. But for giving boundary condition for membrane, how do i get the values of pressure ?

i tried giving comp1.pa in the input of boundary condition for input pressure at the membrane and comp1.pc as output pressure boundary condition for membrane. But i am getting error in the solver.
0 Replies Last Post Jan 12, 2017, 1:04 a.m. EST
COMSOL Moderator

Hello Akanksha Nawale

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content