Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Global Size Node in Mesh Tree

Posted Apr 2, 2017, 7:08 a.m. EDT Heat Transfer & Phase Change, Mesh, Structural Mechanics Version 5.2 0 Replies

Nicholas Goldring Certified Consultant
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi everyone, I have a question about the global size node the in the mesh tree that I can't quite figure out. I don't understand how it is still affecting my meshing scheme when every domain in my geometry has a custom mesh with a custom size and all the boxes ticked with my size parameters defined. Despite this setup, if I switch the global size node from normal to finer, there is a small change. The model does include a mapped and swept quad mesh with a conversion on the boundaries so that tets can go in along side it. Any information would really be appreciated, thank you!
0 Replies Last Post Apr 2, 2017, 7:08 a.m. EDT
COMSOL Moderator

Hello Nicholas Goldring

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content