Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Heat Transfer in Solids-Strain reference temperature problem

Posted Apr 18, 2017, 10:34 a.m. EDT Fluid & Heat, Heat Transfer & Phase Change Version 5.2a 0 Replies

Alex King
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I'm trying to rebuild the model Flat Heat Pipe, Application ID: 43841 in application gallery with different geometry. However, in Heat Transfer (in Solids), Solid 1, Model Inputs, the Strain reference temperature in input shows up, while in the gallery, it did not. I also noticed that in gallery, the Fluid 1 in Heat Transfer is marked as default. How to make it? Unfortunately, there is no model building step details for this model. Any help is much appreciated.
0 Replies Last Post Apr 18, 2017, 10:34 a.m. EDT
COMSOL Moderator

Hello Alex King

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content