Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Plotting electric current

Please login with a confirmed email address before reporting spam

Hi All
I have a 2D joule heating model. I have electric potential applied at two electrodes.(50V and Ground). I have fluid inside my domain and temperature dependent properties which cause joule heating.
I want to calculate the value of electric current in my model. I can plot for current density using cut line 2D at and multiply it by area at constriction(where I drew cut line) but the value are very small as compared to what we get in experimental data. Does anybody have an idea why my current values are too low?

Thanks
Abhinav

0 Replies Last Post May 18, 2017, 3:25 p.m. EDT
COMSOL Moderator

Hello Abhinav Kalkhanda

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.