Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Problem with function assembly and union in the setting of my piezoelectrical study

Posted Jun 26, 2017, 10:09 a.m. EDT Geometry Version 5.2 0 Replies

Edgar Wilfart
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello, I'm working on a model that posseses piezoelectrical actuators. I already set all the parameters I need and I think I would be able to do it right, but when I imported my assembly CAD file, I had some issues when choosing to form an union or an assembly. When choosing the union function, the software just bound two of my pieces together so that I m not able to set piezoelectrical parameters in the good way, so I tried to form an assembly instead, the setting of my piezoelectrical study is then ok but as expected in the results of my modal analysis he separated the most important piece of my model from the other pieces.

If you have any clue for me, that would nice, Thanks
0 Replies Last Post Jun 26, 2017, 10:09 a.m. EDT
COMSOL Moderator

Hello Edgar Wilfart

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content