Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Add an electrical circuit to a coil

Posted Jul 7, 2017, 4:55 a.m. EDT Low-Frequency Electromagnetics 0 Replies

Abdelmoumin Allioua
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Dear all ,

I'm simulating a PM generator and I'm getting a voltage using the multi-turn coil node , and I can only get them separately , the voltage by considering an open circuit and the current by a short circuit .so I want to use an electrical circuit composed of ground node,External I Vs U and a 20Ω resistor .is this correct ? because there is also the Rj of the electrical circuit (Resistance in parallel to pn jonctions) what is it ?

If you have any suggestions about this point I will be immensely grateful.

Sincerely,

Moumen
0 Replies Last Post Jul 7, 2017, 4:55 a.m. EDT
COMSOL Moderator

Hello Abdelmoumin Allioua

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content