Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Meshing a heat exchnager 3D model

Please login with a confirmed email address before reporting spam

Hello,

I have model a heat exchanger inside the COMSOL geometry module. I would like to test the model with turbulent fluid flow and heat transfer. I am facing problems while meshing. I am receiving error for " low minimum element quality". I read other blog regarding this topic but i could not figure out the problem's solution.

How inaccurate the results will be with mesh quality of 0.0020 ?

Can anyone help me to solve this issue ?

Regards,
Drumil Patel

0 Replies Last Post Sep 1, 2017, 7:50 a.m. EDT
COMSOL Moderator

Hello Drumil Patel

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.