Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Gas flow through a porous medium using COMSOL

Please login with a confirmed email address before reporting spam

Model type: 1 D Geometry: Nitrogen gas (viscosity = 1.75x10-5) will flow through a length of 644m (hardened cement paste of porosity = 0.05 and permeability = 4x10-16 m2). Initial condition, p= ambient pressure Boundary Condition: At x=0, P=15Mpa (Constant pressure) and x= 644m, V=1m3 Output required: Pressure build up at x = 644 with time

Can it be done using COMSOL? Is there anyone who can shed some light? If it works we might get this software


1 Reply Last Post Jan 18, 2018, 10:25 a.m. EST
Michael Rembe Certified Consultant

Please login with a confirmed email address before reporting spam

Posted: 6 years ago Jan 18, 2018, 10:25 a.m. EST

I would say YES!!

Best Regards Michael Rembe

-------------------
Michael Rembe
Rembe Consulting PartG mbB
www.rembe-consulting.de


I would say YES!! Best Regards Michael Rembe

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.