Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
The simulation of pm-motor in RMM physics--Identity boundary pair and magnetic insulation boundary
Posted May 14, 2019, 5:39 a.m. EDT Low-Frequency Electromagnetics, Structural & Acoustics, General Version 5.4 0 Replies
Please login with a confirmed email address before reporting spam
Dear all, I am simulating a pm-motor in rotating machinery magnetic(rmm) in comsol. In the process of my simulation, I have met the questions in the title. I have done with in 2 ways. Case one, I imported my entire model with the dxf file. In this way,I cannot created the identity boundary pairs but the magnetic insulation boundaries are correct. Case two, I draw the stator part and rotor part in a file. And I imported the file in comsol. The rest parts of my motor I drew in comsol. I successfully created the identity boundary pairs but the magnetic insulation boundaries are not corrected. The magnets were with the magnetic insulation,I tried defined another magnetic insulation boundaries to override the boundaries that automatically selected in comsol. When I computed,the the magntic flux density of magnets were nearly zero. Anyway, if you met the similar quetions, hope you can write down your opinions or share your ideas generously. I show my sincere thankfulness to you. I uploaded a picture that the physics, it cannot change the boundaries it automatically made. The units in the picture cannot make changes.
Regards Joey
Attachments:
Hello Joey Mai
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.