Error when Compiling Equations: The DAE is structurally inconsistent.

Please login with a confirmed email address before reporting spam

Hi, I'm new here and still struggling to figure out the step by step process to run a simulation. I'm trying to simulate a magnetic field from feeding a Sine AC wave to a copper coil. I've generated a Helix (copper) and a Sphere (air) around it. I used a partition to separate the coil into two sides, and conencted the P node of the Voltage Source to one side, and the N node of the Voltage source to the other side. I've been receiving the 'Error when Compiling Equations: The DAE is structurally inconsistent.' message no matter how i try to change the nodes. I've attached screenshots below. Any help would be greatly appreciated. Thank you!



0 Replies Last Post May 11, 2020, 4:06 AM EDT
COMSOL Moderator

Hello Jenny Smith

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Reply

Please read the discussion forum rules before posting.

Please log in to post a reply.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.