Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
How does the segregated solver control the convergence of segregated steps?
Posted May 1, 2021, 9:07 a.m. EDT Structural & Acoustics, Structural Mechanics Version 5.5 0 Replies
Please login with a confirmed email address before reporting spam
Hi! I have a multiphysics problem and I need to use segregated solver. When I has the setting as indicated in figure 1, I thought the solver will iterate the step u untill it converges. However, when I check the log, I found that the solver just perform 1 iteration then went to the next step while the relative tolerance is not obtained, as indicated in figure2. The relative tolerance for u is 1e-5. How can I set the segregated solver so that it can compute every step until reaching relative tolerance then go to the next step? Thanks.
Tianyu
Attachments:
Hello John Lionel
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.