Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Getting very unrealistic pressure values in simulation of Phased Array Transducer.

Please login with a confirmed email address before reporting spam

Hello,

I am new to COMSOL and trying to design 3D Phased Array Transducer in Acoustic Module. The problem i am getting is actually, when I simulate the pressure levels of Acoustic and Sound are very low like 10^27. What could be the issue?? can any expert guide??


1 Reply Last Post Aug 13, 2021, 6:01 a.m. EDT
Acculution ApS Certified Consultant

Please login with a confirmed email address before reporting spam

Posted: 3 years ago Aug 13, 2021, 6:01 a.m. EDT

You probably need to give more information than that. 10^27 Pa? That is a lot. What is the setup?

-------------------
René Christensen, PhD
Acculution ApS
www.acculution.com
info@acculution.com
You probably need to give more information than that. 10^27 Pa? That is a lot. What is the setup?

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.