Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Changing axis direction

Posted Oct 21, 2021, 11:52 a.m. EDT Version 5.6 2 Replies

Edidiong Etim
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello,

I would like to change the direction of the y-axis so below zero is positive. How do I do that please?

Thank you, Eddy.

2 Replies Last Post Oct 26, 2021, 12:52 p.m. EDT
Acculution ApS Certified Consultant
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 2 years ago Oct 23, 2021, 7:33 a.m. EDT

You can create a new coordinate system based on the existing one. Or you can rotate the entire geometry. Or perhaps invert in your post-processing.

-------------------
René Christensen, PhD
Acculution ApS
www.acculution.com
info@acculution.com
You can create a new coordinate system based on the existing one. Or you can rotate the entire geometry. Or perhaps invert in your post-processing.
Edidiong Etim
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 2 years ago Oct 26, 2021, 12:52 p.m. EDT

I will try that, thank you!

Eddy.

I will try that, thank you! Eddy.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content