Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Composite faces being non applicable when using Partitioning using extended faces

Please login with a confirmed email address before reporting spam

Hello Everyone. I am trying to build a mesh for a high aspect ratio structure to get more details. To do that, I am using the partitioning tool to make a sweep mesh. however I am not abke to select composite faces which are circular and they show up in the selection list as non-applicable even though I have selected the domain.


0 Replies Last Post Jun 22, 2022, 5:04 p.m. EDT
COMSOL Moderator

Hello Mustafeez Shah

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.