Problem in creating mesh

Please login with a confirmed email address before reporting spam

There are some mesh problem when try to mesh analysis of this large geometry, saying "failed to generate mesh for domain". I tried with "Ignore edges". But the problem still exists. How to solve the problem?



1 Reply Last Post Jun 27, 2022, 9:18 a.m. EDT

Please login with a confirmed email address before reporting spam

Posted: 1 week ago Jun 27, 2022, 9:18 a.m. EDT

You have lots of geometric entities that are tangential to or intersecting others. I would suggest using a much finer mesh for your "contained" domains (such as the nerves) as these will then be respected when the enclosing domains are meshed. Create your mesh sequence (making sure it IS a logical sequence) for each desired domain.

Also, be careful of geometric intersections that may create very thin (sliver) geometries.

I would also suggest you could use at least 2 planes of symmetry to simplify your simulation, (and hence simplify your mesh).

You have lots of geometric entities that are tangential to or intersecting others. I would suggest using a much finer mesh for your "contained" domains (such as the nerves) as these will then be respected when the enclosing domains are meshed. Create your mesh sequence (making sure it IS a logical sequence) for each desired domain. Also, be careful of geometric intersections that may create very thin (sliver) geometries. I would also suggest you could use at least 2 planes of symmetry to simplify your simulation, (and hence simplify your mesh).

Reply

Please read the discussion forum rules before posting.

Please log in to post a reply.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.