Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Out of Memory in Stationary Solver

Please login with a confirmed email address before reporting spam

Hello,

I am running heat tranfer and EM simulation on a Windows 10 Enterprise with 128GB RAM memory. I keep getting the error message says "out of memory in staitionary solver." Nothing else is running alongside COMSOL and no other error message is showing up. I even close my browsers.

I tried to reduce the size of the mesh but the simulation is still not able to run. Am I overlooking anything? My model is just a water cooler pipe runing under a circuit board so I assume the simulation shouldn't be too complicated that 128GB RAM memory would be inadequate.



0 Replies Last Post Aug 18, 2022, 6:04 p.m. EDT
COMSOL Moderator

Hello I-Ting Chen

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.