Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How to fix the error "Out of memory in stationary solver."

hi !
I'm Lam, I construct a model.when i play function 'compute' in STUDY and see error "Out of memory in stationary solver." please show me how to fix it. thank you for comment.

4 Replies Last Post Oct 20, 2012, 2:22 PM EDT
Posted: 5 years ago Oct 9, 2012, 5:25 AM EDT

The straightforward advice would be: Plug in more memory! If you can't do that, you can try a coarser mesh or reduce the complexity of your model.

Cheers
Edgar
The straightforward advice would be: Plug in more memory! If you can't do that, you can try a coarser mesh or reduce the complexity of your model. Cheers Edgar

Posted: 5 years ago Oct 11, 2012, 2:40 AM EDT
thank you very much
thank you very much

A.R. Kalaiarasi
Posted: 5 years ago Oct 12, 2012, 4:14 AM EDT
There may be problem in your boundary conditions. check it up
There may be problem in your boundary conditions. check it up

Posted: 5 years ago Oct 20, 2012, 2:22 PM EDT
hi!
thanks for comment.
can you tell me about boundary condition?
hi! thanks for comment. can you tell me about boundary condition?

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.