Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

study

Sir,
In frequency domain study, in stationary solver there are options like automatic, linear, linearized and non'linear which is to be shown. Is there any need to change the relative tolerance value

1 Reply Last Post Dec 5, 2012, 2:28 PM EST
Posted: 5 years ago Dec 5, 2012, 2:28 PM EST
Hi

I use 80-90% ofthe time the defaut settings, even I would say I start always with the default settings, it's only when the solver does not converge, and I'm convinced that nothing else than the solver tweaking is in cause, then I take a closer look to those settings

But that is my way, others that have their own ideas on which solver might be more rapid tendto tweak quicker, it's all wery model dependent

--
Good luck
Ivar
Hi I use 80-90% ofthe time the defaut settings, even I would say I start always with the default settings, it's only when the solver does not converge, and I'm convinced that nothing else than the solver tweaking is in cause, then I take a closer look to those settings But that is my way, others that have their own ideas on which solver might be more rapid tendto tweak quicker, it's all wery model dependent -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.