Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Change x-axis units in table plot
Posted Jan 30, 2013, 11:06 PM EST Results & Visualization Version 4.0a 2 Replies
I have a 3d model of diffusion from a source and am calculating surface integrals of flux over particular features in my geometry. This outputs a table of total flux vs. time point which can then be plotted in a 1d plot group table plot. However, the default output of this is with respect to seconds as used in the time dependent solver and I cannot figure out any way to change the x-axis units to something else for display. When my changes of interest occur on the order of many hours, it is inconvenient to look at things in seconds. Thanks!