Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Message:

Constantinos Tsangarides
What does this message mean:

Parametric solver does not support geometry and mesh dependent parameters?

It solved me things but not sure if it is correct.

2 Replies Last Post May 29, 2013, 9:02 PM EDT
Posted: 4 years ago Apr 4, 2013, 4:59 PM EDT
Hi
In which context did you get that error, if you have selected a Solver Continuation parametrical sweep then it is because that is NOT looping over the geoemtry and the mesh.

To perform a parametric sweep to change the geoemtry and to remesh you need to add a separate "parametric Sweep" node before your solver node

--
Good luck
Ivar
Hi In which context did you get that error, if you have selected a Solver Continuation parametrical sweep then it is because that is NOT looping over the geoemtry and the mesh. To perform a parametric sweep to change the geoemtry and to remesh you need to add a separate "parametric Sweep" node before your solver node -- Good luck Ivar

Posted: 4 years ago May 29, 2013, 9:02 PM EDT
Hi, Ivar!

I also have this problem now. How could I do what you said? Is it described in documentation?

Thanks!
--
Pu, ZHANG ??
Departamento de Física Teórica de la Materia Condensada,
Universidad Autónoma de Madrid,
Madrid, Spain.
Hi, Ivar! I also have this problem now. How could I do what you said? Is it described in documentation? Thanks! -- Pu, ZHANG ?? Departamento de Física Teórica de la Materia Condensada, Universidad Autónoma de Madrid, Madrid, Spain.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.