Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

generating the graph

I am designing a model of saw resonator and i want to see the admittance vs frequency graph but i dont know how to generate this graph , i am new to comsol . please help.

1 Reply Last Post May 3, 2013, 1:46 AM EDT
Posted: 4 years ago May 3, 2013, 1:46 AM EDT
Hi

if you use the lumped port/terminal for your signal input, then COMSOL creates variables ()pre-integrated and global) for you, that you might get under the Results Derived variables.

If you are new to COMSOL it's really worthwhile to
a) attend a few of the COMSOL organised 1 day courses,
b) look at many webinars and the recorded seminars/ videos on the main WEB site

--
Good luck
Ivar
Hi if you use the lumped port/terminal for your signal input, then COMSOL creates variables ()pre-integrated and global) for you, that you might get under the Results Derived variables. If you are new to COMSOL it's really worthwhile to a) attend a few of the COMSOL organised 1 day courses, b) look at many webinars and the recorded seminars/ videos on the main WEB site -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.