Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Flow rate measurement from lorentz force

Hi....

I'm doing a project on lorentz force measurement. Design consists of a conducting liquid flowing through a rectangular cross sectional pipe in between two permanent magnets. On computing i'm always getting an error message. A screen shot of that message is attached here.

Please give suggestions for correcting the error.


1 Reply Last Post Feb 1, 2015, 10:26 AM EST
COMSOL Moderator

Hello Sapna Pattali

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Posted: 3 years ago Feb 1, 2015, 10:26 AM EST
hi....
i am beginner use Comsol
you can help me design model "Flow rate measurement from lorentz force"
you can send your model to me: congchinh173@gmail.com
thanks very much!
hi.... i am beginner use Comsol you can help me design model "Flow rate measurement from lorentz force" you can send your model to me: congchinh173@gmail.com thanks very much!

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.