Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Phase vs. Offset

Posted Jan 20, 2011, 2:32 a.m. EST 1 Reply

Rana Arslan Ali khan
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,

I have bee trying to plot EM phase vs. Offset but couldn't I was able to plot Amplitude vs. Offset but wasn't able to do so for Phase please advise me if someone knows something about it.

Thankyou
1 Reply Last Post Jan 20, 2011, 8:58 a.m. EST
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago Jan 20, 2011, 8:58 a.m. EST
Hi

The phase in [rad] is generally:

phase = atan2( imag(YourVariable) , real(YourVariable) )

COMSOL uses the phasor appraoch so for solutions you can set them at a given phasor value, check the doc, and do an indexed scan on Phasor

--
Good luck
Ivar
Hi The phase in [rad] is generally: phase = atan2( imag(YourVariable) , real(YourVariable) ) COMSOL uses the phasor appraoch so for solutions you can set them at a given phasor value, check the doc, and do an indexed scan on Phasor -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content