Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How to add materials to imported layers

Please login with a confirmed email address before reporting spam

I have a 2D model for a circuit board, and I have imported 5 different layers in geometry. Now I need to add materials on these 5 layers(each one have a kind of material). How to do that?
Now COMSOL separates geometry into little peaces, but I want them be some composed domains for one layers.

1 Reply Last Post Jun 19, 2012, 4:16 p.m. EDT
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago Jun 19, 2012, 4:16 p.m. EDT
Hi

if you have thin metal conductors, I would propose that you consider surface thin conducting layers,then you need only to cut the surface with a workplane without extrusions

--
Good luck
Ivar
Hi if you have thin metal conductors, I would propose that you consider surface thin conducting layers,then you need only to cut the surface with a workplane without extrusions -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.