Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Error Message Non linear solver did not converge at Time=0.005073
Posted Jun 20, 2025, 11:26 a.m. EDT Particle Tracing for Fluid Flow, Results & Visualization, Studies & Solvers Version 6.1 0 Replies
Please login with a confirmed email address before reporting spam
i am trying simulating a water droplet impacting on a flat surface with particles. initially for optimization i am trying to observe results only with a single particle which is placed directly below the bubble impact position. here i am using laminar flow level set module and particle tracing module. the issue is with the convergence of non linear solver. i used user defined mesh with extra fine where the drop and particle is to move .What changes in the solver setting or the model should i do to get convergence.
Attachments:
Hello Chinmay Patil
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.