Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
MOS Model
Posted Aug 17, 2010, 5:25 a.m. EDT 0 Replies
Please login with a confirmed email address before reporting spam
I imported the Model MOSFET Transistor in Comsol 40a.
It runs, so normally it would be no problem, but i try to set up a familiar simulation about an AFM TIP over an Oxide smiconductor Probe. So My Question is:
In these Model the Voltage Drop over the Oxide i think it was not considered, why the modelller have this neglected?
Regards Klaus
Hello Klaus Eller
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.