Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

I want to simulate induced force by helmholtz coil

Please login with a confirmed email address before reporting spam

I want to simulate how much force is induced to the permanent magnet when I use helmholtz coil and put a permanent magnet in the middle of coil.
However, it cannot be simulated.

I guess the setting about permanent magnet is incorrect.
What I want simulate is just a commercial disk shape magnet.
Like this,

www.kjmagnetics.com/proddetail.asp?prod=D101-N52


I attached my simulation file.
Coul any body help me?

Thank you


2 Replies Last Post Feb 2, 2012, 6:09 p.m. EST
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago Feb 2, 2012, 2:56 a.m. EST
Hi

Why use 2 physics, oyu can keep MF and remove the MFNC, then add a new "ampere law" node in MF for the magnet, define Constitutive Relation to MAgentisation and set 1E6 A/m (or whatever fits your magnet) for the My value. Then add a domain Force calculation on the magnet

This should help ;)

--
Good luck
Ivar
Hi Why use 2 physics, oyu can keep MF and remove the MFNC, then add a new "ampere law" node in MF for the magnet, define Constitutive Relation to MAgentisation and set 1E6 A/m (or whatever fits your magnet) for the My value. Then add a domain Force calculation on the magnet This should help ;) -- Good luck Ivar

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago Feb 2, 2012, 6:09 p.m. EST
At first, I appreciate your help.
There was a progress in simulation.
However, I have another question.
In the simulation, even though I changed current density, the force is not changed.
Could you check my model and tell me which one is incorrect?

Thank you so much.
At first, I appreciate your help. There was a progress in simulation. However, I have another question. In the simulation, even though I changed current density, the force is not changed. Could you check my model and tell me which one is incorrect? Thank you so much.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.