See How Modeling and Simulation Is Used Across Industries
Multiphysics modeling and simulation drives innovation across industries and academia — as is evidenced by the many uses showcased in the technical papers and posters presented by engineers, researchers, and scientists at the COMSOL Conference each year.
Draw inspiration from the recent proceedings collected below, or, to find a specific presentation or filter by application area or conference year/location, use the Quick Search tool.
View the COMSOL Conference 2025 Collection
Investigation in this paper aims at performing Mechanical Stress Strain analysis, Thermal, Piezoresistive and Piezoeletric analysis of Silicon Structures using COMSOL. The simulation results have been cross checked by mathematical calculation. Read More
We are working on a microfabricated lysing chip that uses a piezoelectric actuator to provide ultrasonic energy to break apart cells. The device contains pillars with varying dimensions. We hypothesize that increasing the aspect ratio of pillars will increase the efficiency of the ... Read More
Prof. Jeng-Shian Chang received his B.Ec. degree (1974) in Mechanical Engineering from National Taiwan University, Taipei, Taiwan, and M.Sc. degree (1981) in Mechanical Engineering and M.Sc. degree (1983) in Computer Science both from Syracuse University, USA. In 1984 he received the Ph ... Read More
Introduction: Vibration energy harvester can convert mechanical vibration energy into electrical energy and store it in battery for later use. It can create clean renewable energy from vibration movements such as walking, jumping, running, etc. This can convert energy previously wasted ... Read More
We use finite elements simulations in order to study the fluid flow behavior in a chamber of a preconcentrator. We realized that most part of the fluid does not affect our preconcentrator because it is going out the chamber at high distance above it and parallel to the preconcentrator. ... Read More
Vibrating mechanical tank components, such as quartz crystals and surface acoustic wave (SAW) resonators with Q’s in the range of 10e3–10e6, are widely used to implement high-Q oscillators and band pass filters in the radio frequency (RF) and intermediate frequency (IF) stages of ... Read More
Three-dimensional FEM method provided by COMSOL is used to model an inhomogeneous advanced breast tumor of different optical properties for outer layer and inner core in a semi-infinite medium. The running time of FEM by COMSOL for one source and 14 detectors is 17.658s and which of ... Read More
The micro machining technology that emerged in the late 1980’s can provide micron sized sensors and actuators. Actuators are used for the transformation of non- mechanical input energy into mechanical output energy. There are many types of micro- actuation mechanisms, most commonly used ... Read More
The High Flux Isotope Reactor, located at the Oak Ridge National Laboratory, is scheduled to undergo a conversion of the fuel used and this proposed change requires an extensive analysis of the flow through the reactor core. The core consists of approximately 500 very thin and long fuel ... Read More
Articular cartilage is composed by a charged solid matrix (proteoglycan and collagen fibres) and an interstitial fluid phase. The permeability of articular cartilage is a function of compression load applied on the tissue, the solid matrix underwent a compaction that decreased its value ... Read More