See How Modeling and Simulation Is Used Across Industries
Multiphysics modeling and simulation drives innovation across industries and academia — as is evidenced by the many uses showcased in the technical papers and posters presented by engineers, researchers, and scientists at the COMSOL Conference each year.
Draw inspiration from the recent proceedings collected below, or, to find a specific presentation or filter by application area or conference year/location, use the Quick Search tool.
View the COMSOL Conference 2025 Collection
Bolometers are used in a number of applications including night vision cameras, astronomy, and particle physics to measure the power of incident electromagnetic radiation. The general principle of operation is shown below: a strip of conducting material is exposed to incident ... Read More
Aluminum alloys in near-neutral, mildly aggressive solutions, undergo damage accumulation during corrosion, mostly due to the presence of micrometer-sized constituent intermetallic particles (IMP) that create a microstructural discontinuity at which localized corrosion occurs. The ... Read More
Dr. Christian Deville-Cavellin is a Research Engineer at Ugitech's Research Center, since 1995. Ugitech, member of the Schmoltz & Bickenbach group, is a stainless steel, long products producer. C. Deville-Cavellin is responsible for all research topics related to liquid metal ... Read More
As a key component of MEMS, microprocessor with high computing performances is facing with severe thermal challenge due to the increasing power density, miniaturization as well as higher operating temperature requirements, and thermal management in corresponding fields has become one of ... Read More
The MEMS microphone is also called microphone chip or silicon microphone. The pressure sensitive diaphragm is etched directly into a silicon chip by MEMS techniques and is usually accompanied with integrated preamplifier. Most MEMS microphones are variants of the condenser microphone ... Read More
One of the most promising categories of semiconductor-based sensors is organic electrochemical transistor (OECT), which consists of three electrodes (Source, Drain and Gate) and two active layers: electrolyte and conductive polymer. Despite the fact that OECT attracts a lot of attention ... Read More
Pipeline inspection tools present some limitations related to power supply which require recharging after each operation. Using batteries or tethered tools make the duration to inspect any pipeline very limited and time consuming. This paper aims at designing a spherical self-recharging ... Read More
This paper presents a design of polymer based micro heater operating in the temperature range of 200- 250°C which could be operated at low voltage (battery operated). The micro heater has been designed and simulated using COMSOL 4.1, FEM simulation tool. Simulation was performed for ... Read More
The simulation of a micromirror using polyimide as the structural material is presented. The simulation was used to verify the initial design parameters and to explore the different characteristics of the electromechanical device. For simulation simplicity the electrodes are integrated ... Read More
Introduction: RFID system uses a Transponder and the near field communication (NFC) antenna and a matching circuit (Figure-1) in which at least latter two must be optimally designed for a higher efficiency. Typically, RFID antennas are flat inductive coils with 2 to 4 turns and are ... Read More