See How Modeling and Simulation Is Used Across Industries
Multiphysics modeling and simulation drives innovation across industries and academia — as is evidenced by the many uses showcased in the technical papers and posters presented by engineers, researchers, and scientists at the COMSOL Conference each year.
Draw inspiration from the recent proceedings collected below, or, to find a specific presentation or filter by application area or conference year/location, use the Quick Search tool.
View the COMSOL Conference 2025 Collection
Gas-liquid falling film microreactors carry out fast exothermic and mass transfer limited reactions. Since the major rate limiting steps occur on the liquid side, it is important to account for a realistic liquid film profile within the reactor simulation. Based on realistic channel ... Read More
Reperfusion injury is caused by the rapid restoration of blood flow to oxygen-starved tissue. Animal studies show that intermittent periods of occlusion (also called post-conditioning) during reperfusion can limit tissue damage to vital organs such as the heart and brain. These studies ... Read More
Iouri Balachov is a Senior Scientist at SRI International (Menlo Park, CA) where he is leading development of Direct Carbon Fuel Cell technology for clean and efficient power generation from coal, biomass, and a wide variety of carbon containing fuels. Prior to SRI he was an engineer at ... Read More
Scramjet inlet design remains as a key aspect for hypersonic flight. To assess the inlet design, the performance parameters namely; air-capture ratio, total pressure efficiency, inlet drag coefficient, and kinetic energy efficiency are evaluated and analysed. In the current study ... Read More
The paper presents the analysis and optimization of the ventilation system inside of a drying lumber kiln. As with any part of the manufacturing process, improper drying techniques cause quality degradation and considerable amount of energy loose. The improvement and optimization of ... Read More
The effective modeling of enhanced geothermal systems (EGS) requires the coupling of geomechanics, fluid flow and thermal processes. An understanding of the complete system with these coupled processes is vital, not just for reservoir stimulation targeted at enhancing reservoir ... Read More
Harvesting of renewable energy requires efficient energy storage systems. Rechargeable flow batteries offer certain advantages over other energy storage techniques in use, such as the lifting of water, compression of air, flywheel, etc. In a flow battery, electrolyte flowing through ... Read More
PyroProcessing Research and Development Facility (PPRDF) is being setup in IGCAR to develop pyroprocessing technology. It consists of a large argon cell attached with Argon Recirculation and Purification System (ARPS). Once through Argon gas heater is an important process equipment in ... Read More
In this study the flow through a tube filled with highly porous aluminium foam of three different pore sizes is analysed using COMSOL Multiphysics® CFD Module and compared to experimentally determined pressure drop data. Analyzing the flow through an array of pores allow the deduction of ... Read More
The Lévêque problem is an idealized simple situation concerning the influence of the boundary on the distribution of temperature or mass in Hagen-Poiseuille flow. Here, the performance of numerical solutions is examined for a range of Péclet numbers, spanning 11 orders of magnitude. We ... Read More