Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Remesh per step during auxiliary sweep

Please login with a confirmed email address before reporting spam


I'm trying to run a rather simple study where I apply a prescribed displacement to the top boundary of a rectangular geometry (stationary, solid mechanics, 2D).

I'm applying the displacement in steps through an auxiliary sweep. Is it possible to remesh the geometry per step in the sweep? Just with the same number of mesh elements, so no refinements?


0 Replies Last Post Sep 24, 2021, 6:56 a.m. EDT
COMSOL Moderator

Hello Karen Eich Hammer

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.