See How Modeling and Simulation Is Used Across Industries
Multiphysics modeling and simulation drives innovation across industries and academia — as is evidenced by the many uses showcased in the technical papers and posters presented by engineers, researchers, and scientists at the COMSOL Conference each year.
Draw inspiration from the recent proceedings collected below, or, to find a specific presentation or filter by application area or conference year/location, use the Quick Search tool.
View the COMSOL Conference 2025 Collection
The elastic and geometrical properties of Low Density Polyethylene (LDPE) foam are used in this paper to improve the attenuation properties of periodic arrangements of acoustic scatterers known as Sonic Crystals (SCs). A specific recycled profile of LDPE foam is used as elastic-acoustic ... Read More
Sound vibrations are collected from the external environment by the eardrum and are guided to the basilar membrane in the cochlea. Pressure differences in the two scalae of the cochlea result in a traveling wave on the basilar membrane. The tiny displacements are detected by the ... Read More
The interaction of a single particle in straight rectangular channel in laminar flow is modelled explicitly using the set of Navier Stokes equation for the fluid motion and Newton momentum equation for the particle motion in Cartesian coordinate system. The evaluation of integral force ... Read More
Based on recent results from seismology, geochemistry etc. the distinct chemical character of the D’’ layer (lowest part of the mantle around the Earth’s core) has appeared unequivocally. Numerical calculations have been carried out to investigate the effect of the disintegration, mixing ... Read More
Evaporative coolers are viable alternative to air conditioners because of their low power consumption. However, in tropical humid environments the increased humidity that accompanies the cool air in the evaporative coolers causes an uncomfortable wet feeling, since it hinders the ... Read More
This paper describes the thermal and structural combined simulation on COMSOL Multiphysics® of a Microwave (MW) Fin Taper (FT) Spatial Power Combiner (SPC) Power Amplifier (PA), based on rectangular Waveguide (WG). In the SPC based PA's, the captured power is feeded by microstrip ... Read More
The analysis of an impinging jet in a cross-flow and the resulting vortical structures are presented. A computational fluid dynamics simulation utilizing the k-ε model for turbulence is validated in COMSOL Multiphysics® by comparing the results to previous experimental and theoretical ... Read More
Ruptured aortic aneurysm is one of the commonest cause of mortality in developed countries. To avoid it interventional repair is an effective treatment. In the recent years the development of new therapies, such as stent implantations, allows to perform this treatment more and more ... Read More
Oak Ridge National Laboratory’s High Flux Isotope Reactor (HFIR) is the highest flux reactor-based source of neutrons for research in the United States. Thermal and cold neutrons produced by HFIR are used to study physics, chemistry, material science, engineering, and biology. Currently, ... Read More
The discharge properties in low pressure inductively coupled Ar/CH4 plasmas operating at an RF frequency of 13.56 MHz and total gas pressure of 20 mTorr are studied in this work. The calculation of gas flow is performed in coupling with the plasma simulation. The gas flow rate is varied ... Read More
