See How Modeling and Simulation Is Used Across Industries
Multiphysics modeling and simulation drives innovation across industries and academia — as is evidenced by the many uses showcased in the technical papers and posters presented by engineers, researchers, and scientists at the COMSOL Conference each year.
Draw inspiration from the recent proceedings collected below, or, to find a specific presentation or filter by application area or conference year/location, use the Quick Search tool.
View the COMSOL Conference 2025 Collection
The main objective of this study is to verify the compliance of an ongoing nuclear facilities stack design with the ISO 2889 requirements, during normal and off-normal conditions. In particular, with the numerical simulations, they have been identify well-mixed sample locations along the ... Read More
Enhanced operational flexibility and low levels of pollutant emissions are achieved with a sequential arrangement of premixed combustion stages in gas turbines for power generation. In the second – reheat – combustion stage, hot flue gases of approximately 1500K are enriched with fuel ... Read More
In this numerical study, surface acoustic waves (SAWs) are evaluated as a potential disruptive flow technology for enhancing heat transfer in microchannels. Using COMSOL Multiphysics® software, the physics governing acoustics, single-phase-fluid flow and heat transfer are coupled. The ... Read More
This paper utilizes lumped circuits equivalent and pressure acoustics to simulate the behavior of a PA loudspeaker in order to improve its design. Read More
We demonstrate a simple example about how to design my own algorithm for Navier-Stokes equation by weak form PDE and LiveLink™ for MATLAB®. After the computation, we get the same solution as other FEM packages (FreeFEM++ & FeniCs) at each iterative step, and we can see the Navier ... Read More
Deformation prediction is an important part of the structure stability analysis. However, the deformation of bank protection structure which is affected by many factors, such as structural stiffness, earth pressure and hydrostatic pressure. It contains a complex mechanical process, which ... Read More
This work aims at the modelling of a 5 cm^2 Direct Methanol Fuel Cell (DMFC) with mixed serial/parallel serpentine flow fields in terms of current/voltage behavior. One of the main challenge to overcome consists on lowering the so-called methanol cross over from the anode through the ... Read More
For the lack of higher order modes, lumped element (LE) models currently used may be insufficient to predict the system of balanced-armature receiver (BAR). We develop a LE multimode model for BAR in the frequency domain based on the techniques of mode decomposition, truncation, and ... Read More
In the Collaborative Research Centre 692 at TU Chemnitz several academic institutions work on aluminum matrix composites (AMCs). These materials consist of an aluminum matrix, which is reinforced by SiC or Al2O3 particles with dimensions less or equal 1 µm. One main task is finishing ... Read More
A model is presented for heat rejection in the subsurface. Geometries of different dimension are coupled by linear and general extrusions. In that way it is possible to deal with multi-scale physical set-up. An example shows the high influence of groundwater flow. Read More