Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Meshing parasolid imported structure
Posted Mar 25, 2011, 10:34 a.m. EDT 1 Reply
Please login with a confirmed email address before reporting spam
Hi.
I've imported a parasolid strucure to comsol 4.1 by following the user manual instructions.
My structure is a multi-wire birdcage with a metal support at both ends. I've not changed the default meshing configuration. Is there any documentation about the best way to mesh such a structures?
Any example?
Regards,
Javier
I've imported a parasolid strucure to comsol 4.1 by following the user manual instructions.
My structure is a multi-wire birdcage with a metal support at both ends. I've not changed the default meshing configuration. Is there any documentation about the best way to mesh such a structures?
Any example?
Regards,
Javier
1 Reply Last Post Mar 26, 2011, 4:09 a.m. EDT
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
try the default meshing, mostly it's OK. If you have a structure with multiple loops (tores) the mesher might nhave some issues. Then often its better to split the volumes into smaller items, you get more domains to handle and a few interiour boundaries extra, but that often helps the mesher. And you can taylor the mesh locally at will in a much easier way
--
Good luck
Ivar
try the default meshing, mostly it's OK. If you have a structure with multiple loops (tores) the mesher might nhave some issues. Then often its better to split the volumes into smaller items, you get more domains to handle and a few interiour boundaries extra, but that often helps the mesher. And you can taylor the mesh locally at will in a much easier way
--
Good luck
Ivar