Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Error with dynamic probes using General extrusion
Posted Mar 8, 2019, 6:54 AM EST Parameters, Variables, & Functions, Results & Visualization, Equation-Based Modeling 0 Replies
Please login with a confirmed email address before reporting spam
Hi, I am trying to use the same for droplet evaporation. I need to obtain a whole bunch of data in the variables section, eg., Mass fraction, Density and others. I defined a general extrusion operator, then defined variables such as T_sf = genext1(comp1.T), Y_sf = genext1(Y) and so. unfortunately, I get the following error,
Unknown function or operator. – Name: genext1 Can you help me out?
Thanks and regards, Raghavendran Rama
Hello Raghavendran Raman
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.